• KillingTimeItself@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    4
    ·
    4 months ago

    if you want long term CCTV setup properly you should be using ethernet connected security cameras and then transmitting it back to a central server with a hdd always recording. It’s much more reliable and way more cost effective, just requires you running an ethernet cable to where the camera is.

      • KillingTimeItself@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        1
        ·
        4 months ago

        with ethernet the live feed is perfectly fine, and there is no remote downloading, it’s all streamed over the ethernet to a central box which handles everything from there. You might need some decode/encode capabilities, but to my understanding a lot of cameras will run multiple hardware encodes straight from the sensor over to the network already. So you probably don’t need much.

          • KillingTimeItself@lemmy.dbzer0.com
            link
            fedilink
            English
            arrow-up
            1
            ·
            3 months ago

            personally i don’t have a cctv setup at the moment, so i can’t give any recommendations, but you’d be looking for POE capable cameras, and you’d need a POE enabled switch, and a computer connected to that switch in order to handle the incoming data, including software obviously. But it’s probably also dependent on the camera itself, nicer cameras are probably going to be more flexible.

            there are plenty of decent videos about homelab based CCTV setups out there if you’re looking to dig into them a bit more.

    • Natanael@slrpnk.net
      link
      fedilink
      English
      arrow-up
      1
      ·
      4 months ago

      It depends on the type of location, small remote locations might not even get their own local network

      • KillingTimeItself@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        1
        ·
        4 months ago

        yeah and at that point you’re probably not using a microsd card i would figure. You have a small computer in there already, might as well throw in an SSD or something.

        I guess if you needed the sheer capacity of 4TB you might use a micro sd, but you’re probably gambling more than you’re saving at that point.