GrayBackgroundMusic@lemm.eeM to 3DPrinting@lemmy.worldEnglish · 3 months agoCan You Inject Hot Glue Into 3D Printed Molds? | DIY Cable Repair & Protection - spoiler: yes, it's neatyoutu.beexternal-linkmessage-square24fedilinkarrow-up1113arrow-down14
arrow-up1109arrow-down1external-linkCan You Inject Hot Glue Into 3D Printed Molds? | DIY Cable Repair & Protection - spoiler: yes, it's neatyoutu.beGrayBackgroundMusic@lemm.eeM to 3DPrinting@lemmy.worldEnglish · 3 months agomessage-square24fedilink
minus-squareWaltzingKea@lemmy.nzlinkfedilinkEnglisharrow-up4·3 months agoYeah I guess heat-shrink would do the job most of the time. But for when you have connectors that are too big to fit the right heat-shrink over or want to splice more than 2 wires together and want a waterproof seal over them this could be useful.
minus-squareImgonnatrythis@sh.itjust.workslinkfedilinkEnglisharrow-up3·3 months agoWhy not use injectable silicone instead of hot glue though?
minus-squareDroechai@lemm.eelinkfedilinkEnglisharrow-up4·3 months agoHot glue is cheap, easy to handle and easier to clean away is my guesses… I would definitely try a silicone gun
Yeah I guess heat-shrink would do the job most of the time. But for when you have connectors that are too big to fit the right heat-shrink over or want to splice more than 2 wires together and want a waterproof seal over them this could be useful.
Why not use injectable silicone instead of hot glue though?
Hot glue is cheap, easy to handle and easier to clean away is my guesses… I would definitely try a silicone gun